2.7
ENG_UD70437_2
Fonction Stop and Start (XJK - Renault)
Deactivating, activating the
function
Press 1 to deactivate the function.
The 1 switch warning light illuminates.
Pressing again will reactivate the
system. The 1 switch warning light
goes out.
The system is automatically reactivated
each time the vehicle is started using
the start button. ➥ 2.3.
Operating faults
When the “Check Stop & Start” mes-
sage appears on the instrument panel
and the 1 switch is on, this indicates
that the system is deactivated.
Please consult an authorised dealer.
STOP AND START function (3/3)
The engine MUST be
stopped (not put in standby)
before leaving the vehicle.
➥ 2.3.
Special feature: with the engine in
standby, press switch 1 to automati-
cally restart the engine.
Special feature of the automatic
engine re-start
Under certain conditions, the engine
can restart on its own in order to guar-
antee your safety and comfort.
This can occur especially when:
– the outdoor temperature is too low or
too high;
– the battery is not sufficiently charged;
– the vehicle speed is above 3 mph
(5 km/h) (downhill slope, etc.);
– repeated pressing on the brake
pedal or braking system require-
ment;
– ...
The
warning light is displayed on
the instrument panel to notify you of au-
tomatic engine restarting.
Special note: depending on the ve-
hicle, for some of these conditions
automatic restarting of the engine is
inhibited if a door is open.
1
To Next Page
Loading...
