parking distance control.............................
(up to the end of the DU)
driving ........................................................
(up to the end of the DU)
reversing sensor ........................................
(up to the end of the DU)
2.37
ENG_UD73032_3
Aide au parking (XJK - Renault)
Parking distance control
PARKING DISTANCE CONTROL (1/3)
Operating principle
Ultrasonic sensors, indicated by
arrows 1, are fitted in the bumpers to
measure the distance between the ve-
hicle and an obstacle.
This measurement is indicated by
beeps which become more frequent the
closer you come to the obstacle, until
they become a continuous beep when
the vehicle is approximately 20 to
30 centimetres from the obstacle.
The system detects obstacles to the
front, the rear and the sides of the ve-
hicle.
The parking distance control system
is only activated when the vehicle is
driven at a speed below approximately
6 mph (10 km/h).
The parking distance control system
does not take into account towing and
load carrying systems etc.
Special features
Ensure that the ultrasonic sensors indi-
cated by the arrows 1 are not obscured
(by dirt, mud, snow, a badly fitted/at-
tached number plate), impacted, mod-
ified (including paintwork) or obstructed
by any accessory fitted to the front or
rear of your vehicle.
This function is an addi-
tional aid that indicates the
distance between the vehi-
cle and an obstacle whilst
reversing, using sound signals.
Under no circumstances should it
replace the driver’s care or respon-
sibility whilst reversing.
The driver should always be ready
for sudden incidents while driv-
ing: always ensure that there are
no small, narrow moving obstacles
(such as a child, animal, pushchair,
bicycle, stone, post etc.) in the blind
spot when manoeuvring.
1
To Next Page
Loading...
