2.45
ENG_UD68318_2
Avertisseur d’angle mort (XJK - Renault)
Operating faults
If the system detects a fault, the mes-
sage “Check blind spot alert” is dis-
played on the instrument panel. Call an
approved Dealer.
Note: when the engine is started, the
indicator light 3, display B, flashes
three times. It is normal.
– The system’s detection
range operates according
to a standard lane width. If
you are driving in wide traf-
fic lanes, the system might not
be able to detect a vehicle in the
blind spot.
– The system might be disrupted
momentarily if it is exposed to
strong electromagnetic waves
(as beneath high-tension power
lines) or to very poor weather
conditions (heavy rain, snow
etc.). Remain aware of driving
conditions.
There is a risk of accidents.
3
B
C
D
Conditions for non-function
– If the object is not moving;
– if traffic is heavy;
– the road is winding;
– if front and rear sensors both detect
an object at the same time (e.g.
when passing an articulated lorry).
– ...
BLIND SPOT WARNING (4/4)
If a trailer is attached to the vehicle,
the system must be disabled with
the 2 switch.
Because sensors have been in-
stalled in the bumpers, it is advis-
able for any work (repairs, replace-
ments, touching up of paintwork
etc.) to be carried out by a qualified
professional.
To Next Page
Loading...
