5.5
ENG_UD59805_1
Crevaison (FKJK - Renault)
PUNCTURE, EMERGENCY SPARE WHEEL (4/4)
To refit the wheel 7
To carry out this operation, the cable
must be unwound.
– Stand the wheel up with the valve 12
towards you.
– Thread the cable and the compo-
nent 8 through the wheel rim.
– Position wheel valve 12 towards the
ground.
– Insert the cable in the slot 10 up to
the centre of the part 9.
– Insert the part 9 into the wheel 7.
– Turn the handle 11 (movement D) to
lock the cable.
As the punctured wheel
is wider than the emer-
gency spare wheel, when
you place the punctured
wheel in the emergency spare
wheel bay, the vehicle’s ground
clearance is reduced. To pre-
vent damage, proceed carefully
when driving over raised sections
of road and when dismounting
pavements When this is fitted to
the vehicle, which must only be
a temporary measure, the driv-
ing speed must not exceed the
speed indicated on the label on
the wheel.
1
7
12
C
8
From the luggage compartment, tighten
the nut fully in an anti-clockwise direc-
tion (movement C) in order to wind up
the retaining cable, ensuring that the
wheel remains horizontal and the cable
taut.
Final tightening must be carried out with
the spanner 1 in the horizontal position.
Refit the 6 blanking cover.
11
10
D
7
9
To Next Page
Loading...
