1.12
ELECTRIC VEHICLE: charging (5/6)
8
6
7
9
– open charging flap 6;
– open valve 7;
– grab handle 9;
– plug in the vehicle cord;
– make sure you have clicked the
charging cord in properly. To check
the locks, pull on the handle with
moderate force 9 without pressing
button 8.
Warning light
comes on the instru-
ment panel.
If you wish, you can then lock your ve-
hicle. This will make it impossible to
unplug the cord from your vehicle.
Recharging the traction
battery
Switch the ignition off and unlock the
opening elements:
– take the charging cord located in the
boot of your vehicle;
– remove it from its storage bag;
– plug in the end of the cord to the
power supply (terminal, domestic
plug socket, etc);
When charging commences, the hazard
warning lights will flash five times. A
message on the instrument panel will
tell you the remaining charging time.
You do not need to wait until the charge
is at reserve levels to recharge your ve-
hicle.
Precautions to take when removing
from the socket
– Check that the opening elements are
unlocked;
– grab handle 9 and press button 8;
– unplug the charging cord from the
vehicle while holding down button 8.
Warning light
goes out on the
instrument panel;
– close valve 7 then flap 6;
– unplug the cord from the power
supply;
– store the cord in its storage bag and
put away in the boot.
The charging cord cannot be
plugged in or removed while the
opening elements are locked.
NB: It does not matter about the
order of plugging in/unplugging of
the charging cord between the vehi-
cle and the power supply.
To Next Page
Loading...
