reagent tank cap ........................................
(up to the end of the DU)
reagent tank capacity ................................
(up to the end of the DU)
reagent quality ...........................................
(up to the end of the DU)
filling with reagent ......................................
(up to the end of the DU)
reagent (tank) ............................................
(up to the end of the DU)
reagent tank...............................................
(up to the end of the DU)
reagent tank capacity ................................
(up to the end of the DU)
SCR: selective catalytic reduction .............
(up to the end of the DU)
1.101
ENG_UD71019_5
Réservoir réactif (HFE - Renault)
Filling
Useable capacity of the tank: 3.52 gal
(16 litres) approximately.
With the ignition switched off, open the
cover A, then unscrew the cap 1.
Note: ammonium hydroxide vapour
may escape from the cap opening
when the tank temperature is high.
Reagent tank
Please ensure that you comply with the
legislation of your country. It is impor-
tant to remember that failure to respect
regulations in force could lead to legal
action being taken against the vehicle
owner.
Operating principle
The reagent is intended for Diesel en-
gines fitted with the SCR (selective cat-
alytic reduction) system.
Using a reagent reduces the quantity of
nitrogen oxides in exhaust gases.
Reagent consumption in real time de-
pends on vehicle usage conditions, the
equipment fitted, and driving style.
Reagent quality
Use only reagents which conform
to standard ISO 22241 and in accord-
ance with the mark on the tank filler
cap.
REAGENT TANK (1/4)
1
Filler cap: this is specific.
If you have to replace it,
make sure it is identical to
the original cap. Contact
an approved Dealer. Do not wash
the filler area with a high pressure
washer.
If the “XXX MILES (XXX
KM) Failure Top up AdBlue”
warning message appears,
fill the reagent tank and
refer to the filling instructions.
Risk of immobilisation of the ve-
hicle.
The reagent must not come into contact with eyes or skin. If it does, wash
the affected area with plenty of cold water. If necessary, consult a doctor.
A
To fill up with reagent, the engine
must be stopped (not just on
standby in the case of vehicles with
the Stop and Start function). You
must switch off the ignition (please
see the information on “Starting and
stopping the engine” in Section 2).
To Next Page
Loading...
