1.86
ENG_UD64200_2
Éclairages et signalisations extérieures (HFE - Renault)
“See-me-home lighting”
function
This function allows you to briefly switch
on the dipped beam headlights (to pro-
vide light when opening a gate, etc.).
With the engine and lights switched
off and the ring 3 in position 0 or
AUTO, pull the stalk 1 towards you: the
dipped beam headlights come on for
approximately 30 seconds. To increase
this duration, you may pull the stalk up
to four times (total time restricted to ap-
proximately two minutes). The mes-
sage “Follow-me home for _ _ _” along
with the time the lights will be on for is
displayed on the instrument panel to
confirm this action. You can then lock
your vehicle.
To switch off the lights before they go
out automatically, turn ring 3 to any po-
sition, then return it to the AUTO posi-
tion .
EXTERIOR LIGHTING AND SIGNALS (5/6)
Welcome and goodbye
function
(depending on the vehicle)
When the function is activated, the rear
side lights, interior lighting and wel-
come lighting under the rear view mir-
rors, accompanied by two flashes of
the hazard warning lights, come on au-
tomatically when the card is detected or
the vehicle is unlocked.
They switch off automatically:
– approximately one minute after li-
ghting up;
– when starting the engine based on
the position of the lighting stalk;
or
– upon locking the vehicle.
Activating/deactivating the function
From the multimedia screen, select
“Vehicle”, “User settings”, “External
welcome”. Choose “ON” or “OFF” to
activate or deactivate the function.
To Next Page
Loading...
