Renault KWID - Page 49

Jaune Noir Noir texte
2.11
ENG_UD45801_1
boîte de vitesses robotisée (BBA - Renault)

It is a function that enables the vehicle
to move very slowly without depressing
the accelerator pedal.Follow steps as:
– Start the engine as instructed in
“Starting the engine” section.
– With the foot on brake pedal, shift the
rotary knob to “D” and ensure “D” glows
in cluster permanently.
– Release the parking brake and brake
pedal to activate creeping.

Similar to a vehicle
equipped with a manual
gearbox,this vehicle is also
not able to prevent itself
from rolling on a slope if the hand-
brake is not applied or the brake
pedal not pressed continuously in
“N” mode.
The vehicle should always be towed
in Ignition OFF condition with neu-
tral position.
In cold weather start the engine and
wait for a few seconds before rotat-
ing the gear rotary shifter from N to
D/R position to prevent engine stall-
ing.

Switch ON ignition. To start engine,
keep the key in ignition and wait for 3
seconds to initiate starting sequence.
When starting the engine, always place
the rotary knob in “N” position and
depress the brake pedal firmly. The
engine cannot be started unless the
rotary knob is in “N” position and brake
pedal is depressed. Do not press accel-
erator pedal while starting the engine.


– Apply parking brake so that vehicle
will not move.
– Shift the rotary gear knob to “D” while
depressing the brake pedal. Make sure
that gear position indicator displays “D”
in cluster.
– Release the brake pedal and depress
the accelerator gradually. Once the ve-
hicle starts to move, release the park-
ing brake and continue to depress ac-
celerator to start off.

Brake pedal warning light glows if brake
pedal is not pressed when,
– Starting the engine.
– Engine ON and rotary knob shifted
from “N” to R/D.
– Ignition is ON and engine is OFF,
rotary knob shifted from “N” to R/D.
– Driver door is open and R/D is en-
gaged.

Once the vehicle is switched to igni-
tion ON position, the gearbox initial-
izes. This produces a light sound.This
is normal. Crank the engine after 3 sec-
onds.