2.12
ENG_UD45801_1
boîte de vitesses robotisée (BBA - Renault)
When ignition is switched ON, start the
vehicle in neutral “N” with brake pedal
pressed,rotate the gear shifter to D to
engage drive mode.
The letter D appears on the display.The
vehicle is controlled using the acceler-
ator and the brake. Gears will change
automatically at the optimal moment.
Automatic mode takes account of:
– The position and speed of depres-
sion of the accelerator pedal to
assess driving style and select the
optimal gear.
– The position and speed of depres-
sion of the brake to commence
engine braking in preparation for a
downshift.
– If the gear does not engage to R/D
even the rotary knob is shifted,
system shifts automatically after
sometime and creates some noise
from gears.This does not indicate
any malfunction.
However, if the system does not
shift automatically, shift gear knob to
“N” and again shift to R/D in brake
pedal pressed condition.R/D indi-
cator and brake pedal indicator will
flash on the cluster if the rotary knob
shifted to R/D from “N” without de-
pressing brake pedal.
With the brake pedal pressed, rotate
the gear shifter to R. The letter R dis-
plays on the cluster.Release the brake
pedal slowly to allow vehicle to move in
reverse direction. Press the accelerator
pedal gently to increase the speed.
–The engine idle speed (creep function)
is sufficient for parking manoeuvres.
To drive, shift the gear from “R” to “D”
by rotating the gear rotary lever once
the vehicle is stationary.Press brake
pedal to engage a gear when vehicle is
stationary else, warning light will come
on cluster.
When stopped at traffic lights, with the
gear engaged in “D”,keep the ve-
hicle stationary by continu-
ously pressing the brake
pedal without changing the gear shifter
to neutral .
The vehicle will begin moving again:
– Either slowly, if the brake is released
without accelerating (e.g. when in a
traffic jam).
– Or quickly, by releasing the brake
and accelerating.
1.Using accelerator pedal to keep the
vehicle stationary on an uphill slope
while shifting the gear to R/D willl create
a warning buzzer sound.
2.Shifting the rotary knob to R/D while
depressing the accelerator.
3.Maintaining the vehicle stationary on
an uphill slope using creeping function
will create a warning buzzer sound.
To Next Page
Loading...
