The LAGUNA Workshop Repair Manual has been prepared by specialists in repair methods and diagnostics.
The document covers the methods and the diagnostic operations required in order to carry out high quality repairs
on this vehicle.
However, if a removal - refitting operation involves no particular features, difficulties or special tools, the method is
not described in this manual, being considered very simple for a vehicle repair specialist.
The labour times are the result of time and motion studies carried out in our workshops, even though certain
methods have not been described in the Workshop Repair Manual.
UNITS OF MEASUREMENT
●
All dimensions are given in millimetres (mm) except where stated otherwise.
●
Tightening torques are expressed in decaNewtonmetres (daNm.)
●
Pressures are expressed in bar (rappel: 1 bar = 100 000 Pa).
●
Electrical resistance is expressed in ohms (Ω).
●
Voltages are expressed in volts (V).
TOLERANCES
Tightening torques given without a tolerance must be accurate to within:
●
In degrees: ± 3˚.
●
In daNm: ± 10%.
MATERIALS AND TOOLS
The repair methods described for the vehicles in the RENAULT range require special materials and tools in certain
cases. There is a wide choice in the catalogue of special materials and tools.
To Next Page
Loading...
