GB.50
– the induction charging area 1 is over-
heating. Your telephone’s charging
procedure 2 will restart shortly after
the temperature has decreased.
WIRELESS CHARGER (1/2)
Charging procedure
Position your telephone in the 2 induc-
tion area 1.
Phone charging 2 is interrupted in the
following cases:
– an object is detected in the 1 induc-
tion charging area, as indicated by
the charging status 5. A message will
ask you to clear the wireless charg-
ing placement area so that only your
telephone is present;
– the telephone is fully charged, as in-
dicated by the charging status 3;
Introduction
Use the induction charging zone 1 to
charge a telephone without a cable.
Note: for more information on compat-
ible telephones, contact an authorised
dealer or visit the manufacturer’s web-
site.
1
1
2
3
Objects left in the induction charg-
ing area 1 may overheat. You are
advised to place them in the areas
provided for this purpose (storage
compartment, sun visor compart-
ment etc.).
USB
Christie Calagan
Out off the grid
10:45 I -5°C
To Next Page
Loading...
