5.4
TYRE INFLATION KIT (2/4)
In the event of a puncture, use the kit
located under the trunk carpet 1.
With the engine running and the
parking brake applied,
– Connect the compressor hose 3 to
the container inlet 8;
– remove the cap from the container
inflation adapter 2;
– unscrew the valve cap on the rel-
evant wheel and screw on the con-
tainer’s inflation adapter 2;
– the plug 6 must be connected to the
vehicle accessories socket;
4 52
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the parking brake, ask
all passengers to leave the vehicle
and keep them away from traffic.
8
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle’s presence
with a warning triangle or with other
devices as per the legislation apply-
ing to the country you are in.
– press switch 4 to inflate the tyre to
the recommended pressure (please
refer to the information on “Tyre infla-
tion pressure” in Section 4);
– after a maximum of 15 minutes, stop
inflating and read the pressure (on
pressure gauge 5).
Note: While the container emp-
ties (approx. 30 secs), the pressure
gauge 5 briefly shows pressure up to
6 bar, then the pressure drops.
– adjust the pressure: to increase
it, continue inflation with the kit; to
reduce it, press button 7.
6
3
7
1
To Next Page