lighting:
exterior .................................................
(up to the end of the DU)
lights:
adjusting ..............................................
(up to the end of the DU)
lights
adjustment ...........................................
(up to the end of the DU)
headlight beam adjustment .......................
(up to the end of the DU)
electric beam height adjustment ................
(up to the end of the DU)
signals and lights .......................................
(up to the end of the DU)
1.126
ENG_UD72172_2
Réglage des faisceaux (X82 PH2 - Renault)
Load status Control position
Driver only or with passenger 0
All seats occupied 1
Driver with passengers and luggage
(or load) reaching the maximum
permissible all-up weight
2
Driver without a passenger and
with luggage (or load) reaching the
maximum authorised load weight
3 or 4
The table below gives some examples. In all cases, adjust control A according to
the vehicle load so that the road can be seen and other drivers are not dazzled.
Headlight beam adjustment
HEADLIGHT BEAM ADJUSTMENT
On vehicles fitted with this function,
control A allows you to adjust the height
of the beams according to the load.
With the dipped beam headlights on,
press the top 1 of control A to raise
the headlight beam or on the bottom of
control 2 to lower the headlight beam.
A
2
1
To Next Page
Loading...
