1.129
ENG_UD72333_3
Essuie-vitre, lave-vitre avant (X82 PH2 - Renault)
Position D is accessible with the ig-
nition on. Positions C and E are ac-
cessible only with the engine run-
ning.
1
2
F
G
– C automatic wiper function
When this position is selected, the
system detects water on the wind-
screen and triggers the wipers at a
suitable wiping speed. It is possi-
ble to change the triggering thresh-
old and the time sweeps by turning
ring 2:
– F: minimum sensitivity;
– G: maximum sensitivity.
The higher the sensitivity, the quicker
the wipers will react and the faster the
wipe.
Vehicles with automatic wiper
function
With the engine running, press the
stalk 1.
– A a single sweep of the wipers.
A short push will trigger one sweep
of the wipers.
– B switching off.
A
B
C
D
E
WINDSCREEN WASH, WIPE (2/4)
1
Note:
– the rain sensor is only intended as a
driving aid. In the event of reduced
visibility, the driver should manually
activate the wipers. In foggy weather
or during snowfalls, wiping is not au-
tomatically triggered and remains
under the driver’s control;
– in the event of temperatures below
zero, automatic wiping is not acti-
vated when the vehicle is started. It
is automatically activated as soon as
the vehicle exceeds a certain speed
(approximately 5 mph (8 km/h));
– do not activate automatic wiping in
dry weather;
– fully de-ice the windscreen before
activating automatic wiping;
– when washing using a roller type car
wash, return the ring 1 on the stalk B
to the stop position to deactivate au-
tomatic wiping.
To Next Page
Loading...
