1.133
ENG_UD70684_2
Essuie-vitre, lave-vitre arrière (X82 PH2 - Renault)
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of injury.
p
Rear screen wash/wipe
With the ignition on, push and
hold stalk 1, then release.
Holding for longer will trigger three
sweeps of the wipers followed, a few
seconds later, by a fourth, in addition to
the windscreen washer.
Activation/Deactivation of the rear
screen wiper
Engaging reverse gear triggers inter-
mittent wiping (if the front wipers are in
operation). If your vehicle is equipped
with a vehicle settings customisation
menu, you can opt to activate or deacti-
vate this function. Refer to the multime-
dia instructions.
For vehicles not fitted with a settings
customisation menu, you can have this
function deactivated by an authorised
dealer.
In the event of obstacles present on the
rear window (dirt, snow, etc.), the wiper
will try to sweep away all the obstacles.
If an obstacle prevents the blade from
moving, it can be stopped. Remove the
obstacle, wait for around 30 seconds
and reactivate the wiper using the wiper
stalk.
Precautions
– If the weather is icy, check that the
blade is not stuck to the windscreen
before operating the wipers. If you
activate the wiper while the blade is
blocked by ice, you risk damaging
both the blade and the wiping motor.
– Do not operate the wipers on a dry
screen. This will lead to the prema-
ture wear or damage to the blades.
1
REAR SCREEN WASHER, WIPER (2/2)
To Next Page
Loading...
