starting the engine .....................................
(up to the end of the DU)
Stop & Start function..................................
(up to the end of the DU)
indicators:
instrument panel ..................................
(up to the end of the DU)
instrument panel messages.......................
(up to the end of the DU)
engine standby ..........................................
(up to the end of the DU)
Stop & Start ...............................................
(up to the end of the DU)
instrument panel ........................................
(up to the end of the DU)
2.8
ENG_UD75665_4
Fonction Stop and Start (X82 PH2 - Renault)
Stop and Start function
FUNCTION STOP AND START (1/4)
The engine MUST be
stopped (not put in standby)
before leaving the vehicle.
➥ 2.3.
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions.
The system is activated automati-
cally when the vehicle is started. While
driving, the system stops the engine
(standby) when the vehicle is at a
standstill (traffic jam, traffic lights, etc).
Conditions for engine
standby
The vehicle has set off from where it
was parked;
For automatic gearboxes:
– gearbox is in position D, M or N;
and
– the brake pedal is pressed.
Depending on the vehicle, if the
warning light flashes and the
message “Press brake pedal” ap-
pears on the instrument panel, it in-
dicates that the brake pedal is not
sufficiently depressed;
and
– the accelerator pedal is not de-
pressed;
and
– the speed is zero.
The engine remains on standby if posi-
tion P is selected, or if position N is se-
lected with the handbrake engaged and
the brake pedal released.
For manual gearboxes:
– the gearbox is in neutral;
and
– the clutch pedal is released.
Depending on the vehicle, if the
warning light flashes and the
message “Release Clutch pedal” ap-
pears on the instrument panel, this
indicates that the clutch pedal is not
sufficiently released;
and
– the vehicle speed is zero.
Keep your vehicle station-
ary when the engine is
on standby (shown by the
warning light
on the
instrument panel).
For all vehicles:
The warning light
on the instru-
ment panel is lit when the engine is on
standby. The vehicle equipment re-
mains operational while the engine is
stopped.
When the engine switches to standby,
the steering assistance may no longer
be operational.
In this case it becomes operational
again when the engine is no longer on
standby or the speed exceeds approxi-
mately 0.62 mph (1 km/h) (downhill,
slope etc.).
To Next Page
Loading...
