2.46
ENG_UD67701_1
Avertisseur d’angle mort (X82 PH2 - Renault)
BLIND SPOT WARNING (6/6)
Limitation of the system operation
– The ultrasonic detection zones should be kept clean and free of any modifications in order to ensure the proper op-
eration of the system.
– Small objects moving close to the vehicle (motorcycles, bicycles, pedestrians, etc.) may not be recognised by the system.
– When turning into a bend, the ultrasonic sensors may temporarily cease to detect vehicles in adjacent lanes.
– The function may warn you late if two other vehicles are approaching from the rear, driving side by side in the adjacent lanes
(i.e. driving on a 3-lane road) at a much higher speed than your vehicle.
– The system may not provide a warning when the other vehicles are travelling at a significantly different speed.
– If the vehicle is being overtaken by a long vehicle (e.g. heavy goods vehicle overtaking at a similar speed to the vehicle) the
system may interrupt the warning before the end of the manoeuvre.
– The vehicle is travelling on a winding road.
Deactivating the function
You must disable the function if:
– the ultrasonic sensor zones have been damaged (front and rear bumpers);
– the vehicle is fitted with a towbar that is not recognised by the system.
To Next Page
Loading...
