2.58
ENG_UD68362_1
Alerte de détection de fatigue (X82 PH2 - Renault)
– repeatedly press the control 3 up or
down until you reach the Fatigue de-
tection warning menu, then press the
switch 2 OK .
– press the 2 OK switch again to acti-
vate or deactivate the function.
Operation
The function is set to notify the
driver if:
– the vehicle is driven for more than
five minutes after each vehicle stop;
– the vehicle speed is greater than ap-
proximately 40 mph (65 km/h);
and
– Approximately 10 minutes have
passed since the deletion of the pre-
vious warning.
The function triggers an alert if the
system detects repeated signs of fa-
tigue in the driver at the steering wheel.
FATIGUE DETECTION WARNING (2/2)
When a risk of fatigue is detected,
the message “Fatigue warning have a
break” is displayed on the instrument
panel accompanied by a beep.
Press switch 2 OK to delete the warn-
ing.
It is advisable to stop as soon as pos-
sible for a break.
Note:
– if the warning is not deleted by press-
ing switch 2 OK, the beep repeats;
– the function may interpret certain
driving styles as a sign of tiredness
(sporty driving, incorrect driving etc.)
or driving along a road which is in
poor condition.
Operating faults
If the system detects a fault, the mes-
sage “Check fatigue warning” is dis-
played on the instrument panel. Call an
approved Dealer.
2
Vehicles not fitted with a multimedia
screen
– With the vehicle at a standstill, press
and hold the switch 2 OK to access
the settings menu;
– repeatedly press the control 3 up or
down until you reach the “Driving as-
sistance” menu. Press the switch 2
OK;
3
To Next Page
Loading...
