5.3
ENG_UD65809_1
Crevaison, roue de secours (X82 PH2 - Renault)
To put the spare wheel back B
Proceed in reverse order. Check that
wheel carrier 4 is correctly positioned
before tightening nuts 3 and 5.
Note: do not fit the hubcap on the emer-
gency spare wheel, so that you do not
hide the safety message on the label on
the emergency spare wheel. The mes-
sage indicates the 50 mph (80 km/h)
speed limit. Please abide by the limits
set by the local legislation of the coun-
try that you are in.
PUNCTURE, EMERGENCY SPARE WHEEL (2/2)
Emergency spare wheel
On equipped vehicles, use the tool A
comprising:
– wheelbrace 2;
– for some versions, special end
piece 1 (which must be added).
These components are stored in the
tool kit ➥ 5.8.
To take out emergency spare wheel B
Using the tool A, completely unscrew
the nut 5 (right-hand side) and partially
unscrew the nut 3 (left-hand side) until
the notch of the wheel carrier 4 is re-
leased from the nut 3.
Move it up and down and from side to
side to release the emergency spare
wheel.
Depending on the vehicle, a note in the
tool kit covers these instructions.
A
4
3
B
5
1
2
2
Do not touch the exhaust
system.
Risk of burns.
To Next Page
Loading...
