Jaune Noir Noir texte
1.44
ENG_UD60275_2
Ordinateur de bord (XBC - Renault)ENG_NU_1321-2_XBC_Renault_1
DISPLAY
Interpreting the display selected
Mileage before service
With the ignition switched on, the engine not running and
the display set to “SERVICE INTERVALS”, press the
button 1 or 2 for approximately 10 seconds to display the
mileage before service (distance or time to the next ser-
vice). When the distance value approaches its limit, there
are several possible scenarios:
– distance/time remaining is less than 1500 km or one
month: the message “Service” is displayed accompa-
nied by the nearest term (distance or time);
– distance equals 0 km or date of service reached: the
message “Service required” is displayed and depending
on the variants accompanied by warning light
©.
The vehicle requires a service as soon as possible.
Resetting: to reset the distance before service, press and hold button 1 for approximately 10 seconds until the display shows
the service mileage without flashing.
NB: if a service is performed without changing the engine oil, only the mileage before the next service should be reset. In the
event of an oil change, both the distance before the next service and the next oil change should be reset.
ON-BOARD COMPUTER (4/4)
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY.
To Next Page
Loading...
