EasyManua.ls Logo

Renault TRIBER 2021 - Running in, Ignition switch

Renault TRIBER 2021
202 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Jaune Noir Noir texte
2.2
ENG_UD68122_2
Rodage / Contacteur de démarrage (XBC - Renault)ENG_NU_1321-2_XBC_Renault_2
RUNNING IN, IGNITION SWITCH
Running in
For the first 1,000 km, do not exceed
80 km/h in the highest gear.
You may only expect top performance
from your vehicle after approximately
3,000 kms.
Oil change frequency: Please refer to
your vehicle’s maintenance schedule.
NOTE : During the running in period, do
not accelerate hard while the engine is
still cold and do not let the engine to run
in higher rpm.
Service intervals: refer to the
Maintenance Schedule for your vehicle.
Stop and steering lock
position St
To lock: remove the key and turn the
steering wheel until the steering column
locks.
To unlock: turn the key and the steering
wheel slightly.
Accessories position A
When the ignition is switched off, any
accessories (radio, etc.) will continue to
function.
Ignition on position M
The ignition is switched on:
– the engine may be started.
Start position D
If the engine fails to start at the first at-
tempt, turn the key back to home posi-
tion before activating the starter again.
Release the key as soon as the engine
starts.
NOTE:
Do not attempt to start/crank the
engine in running/geared condi-
tion;
Do not attempt to crank the engine
more than 5 times repeatedly, if
the vehicle doesnot starts. Wait
for sometime and crank the
engine. If the vehicle didnt starts,
contact the nearby authorised
dealer;

Table of Contents

Related product manuals