Renegade COMMANDO - User Manual

Questions and Answers

S
Sarah GallagherSep 10, 2025
Why is the battery getting discharged on my Renegade COMMANDO?
- M
  Ms. Rebecca LynchSep 12, 2025
  If your Renegade Motorcycle battery is getting discharged, you can: * Replace any blown fuses. * Remove, clean, and then reconnect the negative/earth terminal if there's a loose connection, dust, or accumulation. * Check the battery charging if the battery is defective. * Crank the engine and check for regulator output voltage: >14V at 2000RPM if the regulator unit is defective or has low output voltage. * Confirm the magneto coil resistances are within specifications, replace if required, if the magneto coil is defective. * Confirm that there is no short circuit between ground and phases of coil if the magneto coil short with ground.
P
Pamela JonesAug 25, 2025
Why are the brakes on my Renegade COMMANDO poor?
- J
  Jeffrey MillerAug 25, 2025
  To address poor braking on your Renegade Motorcycle, start by ensuring the brakes are properly adjusted. If there's oil or grease on the lining, drum, or disc, clean and refit these components. Replace worn or unevenly worn linings. If the drum is scored or shows uneven wear, either rectify it or replace the drums.
K
Katie HooverAug 26, 2025
Why does my Renegade Motorcycle engine lack power?
- J
  jonathanhughesAug 26, 2025
  If your Renegade Motorcycle engine lacks power, try these solutions: * Clean the fuel line, pipes, and vent holes to address a faulty fuel supply. * Adjust the clutch cable free play if it's excessive and the clutch is slipping. * Adjust the accelerator cable free play if it's excessive. * Clean or replace a choked air filter. * Tighten a loose carburetor mounting, replacing the rubber hose/intake if necessary. * Properly readjust a rear chain or brakes that are adjusted too tightly. * Inflate under-inflated tires to the correct pressure.
S
Steven OconnellAug 27, 2025
Why is my Renegade COMMANDO engine overheating?
- J
  Jessica WilsonAug 28, 2025
  If your Renegade Motorcycle is overheating, you should: * Check and correct any transmission clutch slipping. * Check and correct any suction/intake system/parts leakage. * Check and correct incorrect fueling and ignition timing adjustments. * Clean the cylinder fins/casting area if they are clogged with mud or dirt. * Check and correct any silencer/exhaust system/parts leakage. * Check and correct incorrect carburetor adjustments. * Check and correct any cooling system/parts leakage.
P
parkeradamAug 29, 2025
Why does my Renegade COMMANDO have high fuel consumption?
- K
  kevin12Aug 29, 2025
  If your Renegade Motorcycle has high fuel consumption, consider the following: * Inflate under-inflated tires to the correct pressure. * Check for fuel leakage and adjust as per the service manual. * Check and correctly adjust incorrect carburetor settings. * Check and rectify any breather system leakage. * Clean or replace a choked air filter.
W
wardmariaNov 20, 2025
How to fix a Renegade COMMANDO Motorcycle that won't start or crank?
- J
  Jessica WhiteNov 21, 2025
  If your Renegade Motorcycle isn't starting and doesn't crank, here's what you can check: * Ensure the ignition switch is in the "ON" position. * Verify the engine kill switch is in the "ON" position. * Inspect the fuel tank cap vent hole for clogs and clean if necessary. * Examine the HT Lead for damage and replace if needed. * Confirm the spark plug cap/lead is firmly connected. * Tighten a loose spark plug. * If the spark plug is dirty or fouled, clean it and reset the gap. If the spark plug insulation is cracked, replace the spark plug. * Check the starter motor and starter relay, replacing if faulty. * Clean any clogged fuel lines or pipes. * Adjust the clutch cable free play if the clutch is slipping. * Replace the starter relay if it's not working. * If the c...
L
lbrownSep 18, 2025
Why are the trafficators not working on my Renegade COMMANDO Motorcycle?
- A
  Alexander McleanSep 18, 2025
  If the trafficators on your Renegade Motorcycle are not working: * Check and correct loose or improper connections. * Replace fused bulbs. * Replace a defective switch. * Replace a defective flasher.
C
csmithSep 22, 2025
Why does the brake light remain on in my Renegade Motorcycle?
- C
  Christopher HerringSep 22, 2025
  If the brake light remains on in your Renegade Motorcycle: * Adjust the switch properly if it's not adjusted properly. * Replace a sticky switch. * Check and correct improper brake setting.
K
kimberlylewisSep 8, 2025
Why are the lights not illuminating on my Renegade Motorcycle?
- J
  Joshua BlakeSep 8, 2025
  If the lights on your Renegade Motorcycle are not illuminating, check: * The ignition key is in the ON condition. * The battery has more than 12.4 volts; charge if required. * Replace any blown fuses. * Check the continuity of the control switch if it's not working. * Replace any fused bulbs/LEDs. * Ensure all the connectors are firmly connected with wiring. * Check the continuity of the lighting circuit in the wiring harness if it's defective.
E
Elizabeth TaylorSep 5, 2025
Why is my Renegade COMMANDO getting off while running?
- L
  Laurie RushSep 5, 2025
  If your Renegade Motorcycle is getting off while running (engine starts, but runs irregularly & stops/stalls), you can: * Clean the fuel line, tap, and vent hole if there's a faulty fuel supply. * Increase the idling speed if it's very low. * Check and correct any transmission clutch slipping. * Check and correct any suction/intake system/parts leakage.

Summary

Important Points

A Few Words on Safety

Essential safety advice and precautions for riders and others.

Vehicle Identification

Vehicle Identification Number

Information on VIN and engine number for vehicle identification and warranty.

Important Safety Information

Wear Protective Gear

Guidance on essential protective gear for rider safety.

Petrol and Exhaust Fumes

Component Location & Function

Left Control

Right Control

Instrument Panel

Ignition Switch and Locks

Steering Lock

Fuel Tank Cap

Fuel Valve & Choke

Choke Lever

Operating Controls

Clutch Lever

Front Brake Lever

Throttle

Drive Mechanisms

Rear Brake Pedal

Gear Shift Lever

Riding Readiness

Is Your Motorcycle Ready to Ride?

Pre-Ride Inspection Checklist

Basic Operation and Riding

Starting & Stopping the Engine

Engine Oil Management

Periodical Maintenance Schedule

Troubleshooting: Starting and Fuel Issues

Vehicle Not Starting (Cranking Issues)

Diagnosing and fixing problems preventing the engine from cranking.

Troubleshooting: Engine and Power Issues

Engine Misfiring or No Start

Troubleshooting steps for engine misfires or failure to start after cranking.

Engine Lacks Power

Troubleshooting: Overheating and Starter Issues

Engine Overheating

Identifying and resolving causes of engine overheating.

Starter Motor Malfunctions

Troubleshooting common problems with the starter motor.

Troubleshooting: Horn and Fuel Indicator Issues

Troubleshooting: Battery and Running Issues

Battery Discharge Issues

Identifying and resolving battery drain problems.

Vehicle Stalling or Irregular Running

Troubleshooting reasons for the vehicle stalling or running erratically.

Troubleshooting: Lighting and Gear Shifting Issues

Gear Shifting Difficulties

Troubleshooting: Brake and Stability Issues

Brake Performance Issues

Diagnosing and fixing problems with brake performance.

Warranty Policy

Warranty Registration Form

Ownership & Vehicle Information

Vehicle Installation and Delivery Certificate

PDI Check Sheet

Renegade COMMANDO Specifications

General

Front Suspension	Telescopic Forks
Fuel System	Carburetor
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Brake	Disc
Rear Brake	Drum
Rear Suspension	Twin shock absorbers