Renegade COMMANDO - User Manual

Questions and Answers

M
Matthew WilsonAug 23, 2025
What to do if my Renegade COMMANDO Motorcycle cranks but won't start (engine misfiring)?
- J
  Jonathan PotterAug 23, 2025
  If your Renegade Motorcycle cranks but doesn't start and the engine is misfiring, consider the following: * Clean the throttle body/petrol tank and fill the tank with fresh petrol if there's water in the fuel system. * Tighten any loose intake hoses/lines, replacing them if necessary. * Ensure the spark plug is not loose. * Clean or reset the gap on a fouled spark plug, or replace it if the insulation is broken. * Make sure all connections in the ignition coil and suppressor cap are secure.
E
Elizabeth TaylorSep 5, 2025
Why is my Renegade COMMANDO getting off while running?
- L
  Laurie RushSep 5, 2025
  If your Renegade Motorcycle is getting off while running (engine starts, but runs irregularly & stops/stalls), you can: * Clean the fuel line, tap, and vent hole if there's a faulty fuel supply. * Increase the idling speed if it's very low. * Check and correct any transmission clutch slipping. * Check and correct any suction/intake system/parts leakage.
M
Mr. Nathaniel BrownSep 4, 2025
Why is the horn on my Renegade COMMANDO not working or sounding improper?
- W
  wyatt35Sep 4, 2025
  If the horn on your Renegade Motorcycle isn't working or the sound is improper, verify: * The ignition key is in the ON position. * The battery has more than 12.4 volts; charge if required. * All connectors are connected with wiring. * Replace any blown fuses. * Set the horn by adjusting the screw.
P
Paul WalterSep 2, 2025
Why does the starter motor on my Renegade COMMANDO struggle to crank?
- M
  Monica OwenSep 3, 2025
  If the starter motor on your Renegade Motorcycle struggles to crank, you can: * Ensure the battery voltage is more than 12.4 volts. * During cranking, the battery voltage should not drop below 6 volts. * Make sure all connectors are firmly connected with wiring. * Check and replace a malfunctioning starter switch. * Check and replace a starter relay that is not working. * Check the starter motor for any obstruction.
S
Shane GilmoreSep 1, 2025
What if the starter motor operates but my Renegade COMMANDO engine doesn’t start?
- M
  Malik FisherSep 1, 2025
  If your Renegade Motorcycle's starter motor operates but the engine doesn’t start, you can: * Check and rectify the engine clutch. * Check and rectify the engine starter gear. * Check for a spark by removing the spark plug; if there's no spark, check the ignition circuit. * Ensure the proper gap in the spark plug.
T
Toni ShawAug 30, 2025
What to do if the starter motor on my Renegade COMMANDO Motorcycle doesn't work?
- D
  Denise WhiteAug 30, 2025
  If the starter motor on your Renegade Motorcycle doesn't work, make sure of the following: * The ignition key is in the ON position. * The kill switch is in the ON position. * The battery has more than 12.4V; charge if required. * Replace any blown fuses. * Ensure all connectors are firmly connected to the wiring. * Check the continuity of the wiring harness starting circuit if it's defective. * Check the continuity of the starter switch if it's not working. * Check the starter relay operation if it's defective.
P
parkeradamAug 29, 2025
Why does my Renegade COMMANDO have high fuel consumption?
- K
  kevin12Aug 29, 2025
  If your Renegade Motorcycle has high fuel consumption, consider the following: * Inflate under-inflated tires to the correct pressure. * Check for fuel leakage and adjust as per the service manual. * Check and correctly adjust incorrect carburetor settings. * Check and rectify any breather system leakage. * Clean or replace a choked air filter.
S
Steven OconnellAug 27, 2025
Why is my Renegade COMMANDO engine overheating?
- J
  Jessica WilsonAug 28, 2025
  If your Renegade Motorcycle is overheating, you should: * Check and correct any transmission clutch slipping. * Check and correct any suction/intake system/parts leakage. * Check and correct incorrect fueling and ignition timing adjustments. * Clean the cylinder fins/casting area if they are clogged with mud or dirt. * Check and correct any silencer/exhaust system/parts leakage. * Check and correct incorrect carburetor adjustments. * Check and correct any cooling system/parts leakage.
K
Katie HooverAug 26, 2025
Why does my Renegade Motorcycle engine lack power?
- J
  jonathanhughesAug 26, 2025
  If your Renegade Motorcycle engine lacks power, try these solutions: * Clean the fuel line, pipes, and vent holes to address a faulty fuel supply. * Adjust the clutch cable free play if it's excessive and the clutch is slipping. * Adjust the accelerator cable free play if it's excessive. * Clean or replace a choked air filter. * Tighten a loose carburetor mounting, replacing the rubber hose/intake if necessary. * Properly readjust a rear chain or brakes that are adjusted too tightly. * Inflate under-inflated tires to the correct pressure.
P
Pamela JonesAug 25, 2025
Why are the brakes on my Renegade COMMANDO poor?
- J
  Jeffrey MillerAug 25, 2025
  To address poor braking on your Renegade Motorcycle, start by ensuring the brakes are properly adjusted. If there's oil or grease on the lining, drum, or disc, clean and refit these components. Replace worn or unevenly worn linings. If the drum is scored or shows uneven wear, either rectify it or replace the drums.

Summary

Important Points

A Few Words on Safety

Essential safety advice and precautions for riders and others.

Vehicle Identification

Vehicle Identification Number

Information on VIN and engine number for vehicle identification and warranty.

Important Safety Information

Wear Protective Gear

Guidance on essential protective gear for rider safety.

Petrol and Exhaust Fumes

Component Location & Function

Left Control

Right Control

Instrument Panel

Ignition Switch and Locks

Steering Lock

Fuel Tank Cap

Fuel Valve & Choke

Choke Lever

Operating Controls

Clutch Lever

Front Brake Lever

Throttle

Drive Mechanisms

Rear Brake Pedal

Gear Shift Lever

Riding Readiness

Is Your Motorcycle Ready to Ride?

Pre-Ride Inspection Checklist

Basic Operation and Riding

Starting & Stopping the Engine

Engine Oil Management

Periodical Maintenance Schedule

Troubleshooting: Starting and Fuel Issues

Vehicle Not Starting (Cranking Issues)

Diagnosing and fixing problems preventing the engine from cranking.

Troubleshooting: Engine and Power Issues

Engine Misfiring or No Start

Troubleshooting steps for engine misfires or failure to start after cranking.

Engine Lacks Power

Troubleshooting: Overheating and Starter Issues

Engine Overheating

Identifying and resolving causes of engine overheating.

Starter Motor Malfunctions

Troubleshooting common problems with the starter motor.

Troubleshooting: Horn and Fuel Indicator Issues

Troubleshooting: Battery and Running Issues

Battery Discharge Issues

Identifying and resolving battery drain problems.

Vehicle Stalling or Irregular Running

Troubleshooting reasons for the vehicle stalling or running erratically.

Troubleshooting: Lighting and Gear Shifting Issues

Gear Shifting Difficulties

Troubleshooting: Brake and Stability Issues

Brake Performance Issues

Diagnosing and fixing problems with brake performance.

Warranty Policy

Warranty Registration Form

Ownership & Vehicle Information

Vehicle Installation and Delivery Certificate

PDI Check Sheet

Renegade COMMANDO Specifications

General

Front Suspension	Telescopic Forks
Fuel System	Carburetor
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Brake	Disc
Rear Brake	Drum
Rear Suspension	Twin shock absorbers