Reneka International – Instruction of use – Edition 01/2008 – Page 3
RECOMMENDATIONS
Only RENEKA’s After Sales Service and that of its distributor are authorised to carry out the servicing of RENEKA
coffee machines.
Please post this notice next to your machine. It will thus be readily available for consultation by users as need be.
RENEKA International declines all responsibility for any damage that may arise as a result of failure to maintain the
machines as need be, of inappropriate operations on the machine, or from the use of non-RENEKA parts.
RENEKA reserves the right to carry out any desirable modification without notice so as to update the product to meet
market requirements or make technical improvements.
SECURITY
The machine should be placed on a horizontal surface which is stable and sturdy enough to bear its weight, in a
sufficiently ventilated atmosphere, so that there is no danger from the humidity caused by the machine.
Leak enough space around the machine so that air circulates around it.
Air admission louvers of the machine should not be obstructed by towels etc.
The supply cable should not be in contact with the source of heat nor should it be hanging from the surface on
which the machine is placed nor be crushed by the machine.
Do not immerse all or even part of the machine.
Do not place the machine in an area where there may be projections.
Set the ON/OFF machine on “O” (Off) before moving the machine and before plugging it out.
Leave the machine to cool down and plug it out before taking on any repairs on the machine.
Do not use the machine for any other use except for that for which it is meant.
Avoid all contact with the hot zones (cup tray, brewhead, hot water and steam outlets)
Avoid exposure to steam and hot water projections.
Do not use the machine if there are children in the vicinity.
The machine should not be used by children.
USE OF SOFTENED WATER
Whatever water treatment method is used, it is important that the coffee machine operates on a permanent basis with
water at a maximum of 7 °TH (resin softener) or 3° KH (Brita system).
Lime scaling, whether due to poor functioning or bad maintenance of the water treatment systems, gradually limits the
performance of the machine and the quality of the coffee obtained while increasing the exploitation costs and the
technical risks.
IMPORTANT
Problems connected with scaling are not covered by the guarantee and/or the maintenance contracts.
It is therefore important to regenerate your softener every 2 weeks, in the case of a resin softener.
In the case of Brita-type water treatments, refer to the instructions of your installer.
To Next Page
Loading...
