Reneka International – Instruction of use – Edition 01/2008 – Page 8
4. GTV procedure (emulsion/steam) :
For optimal operation of the reneka GTV system, we advise you to use fresh milk at the ideal temperature of 41 °F (5°C)
1) The reneka GTV system is set by the factory for the production of a maximum volume of consistent foam.
2) You may obtain finer and more consistent foam by removing the red o-ring (ref 9208065) from the accelerating coat
To restore the initial conditions, just replace the red o-ring
4.1 Emulsion mode
- Press the GTV button to - Place a container with cold - Push the GTV button to start the
Flush out the nozzle milk (between 2 and 7°C) cycle.
(It stops automatically) under the emulsifier It stop automatically when the milk
reaches the right temperature
4.2 Steam mode
- Remove the emulsifier tube from - Press the GTV button to flush - Place the container under
the GTV nozzle out the GTV nozzle the GTV nozzle
(it stops automatically)
- Press the GTV button twice - Put back the emulsifier tube
to switch to the steam mode
Note: To clean the GTV nozzle, please refer to page 27.
To Next Page
Loading...
