Renesas EK-RA4M3 - Figure 18. Opening the Configurator; Modifying, Generating, and Building the Quick Start Example Project

Renesas RA Family EK-RA4M3 – Quick Start Guide
R20QS0019EG0100 Rev.1.00 Page 19 of 26
Nov.17.20
5.3 Modifying, Generating, and Building the Quick Start Example Project
This section provides instructions to modify the Quick Start example project. The Quick Start example project
can be modified by editing the source code and reconfiguring the properties of the MCU peripherals, pins,
clocks, interrupts, and so forth.
Note: The specific modifications that can be performed to the Quick Start example project are not
prescribed in this QSG. User discretion is advised while modifying the Quick Start example project.
1. Once the Quick Start example project is imported, click the configuration.xml file to open the
configurator. The configurator provides an easy to use interface to configure the properties of the MCU
peripherals.
Figure 18. Opening the Configurator