Renishaw TS27R Installation Guide

i
www.renishaw.com/ts27r
Contents
Before you begin ...................................................................1-1
Warranty ...........................................................................1-1
CNC machines ......................................................................1-1
Care of the probe ....................................................................1-1
Patents ............................................................................1-1
Intended use........................................................................1-1
Safety .............................................................................1-2
Information to the user ...........................................................1-2
Information to the machine supplier/ installer..........................................1-2
Information to the equipment installer ...............................................1-2
Product basics .....................................................................2-1
TS27R probe system .................................................................2-1
Introduction.........................................................................2-1
Achievable set-up tolerances ...........................................................2-2
Recommended rotating tool feedrates ....................................................2-2
First touch – machine spindle rev/min ....................................................2-2
First touch – machine feedrate ..........................................................2-2
Second touch – machine feedrate .......................................................2-2
Software routines ....................................................................2-2
Specication ........................................................................2-3
System installation..................................................................3-1
Mounting the probe on the machine table .................................................3-1
Spirol
®
pins .........................................................................3-2
Cable .............................................................................3-2
Conduit for cable protection ............................................................3-2
Interfaces ..........................................................................3-3
Recommended connection diagram for TS27R with HSI-C interface.............................3-4
Recommended connection diagram for TS27R with HSI interface...............................3-5
Recommended connection diagram for MI 8-4 interface with CNC controller ......................3-6
Recommended connection diagram for TS27R with MI 8-4 interface ............................3-7
Fitting the stylus and captive link ........................................................3-8
Screw torque values .............................................................3-8
Fitting the stylus ................................................................3-8
Captive link....................................................................3-8

Renishaw TS27R Specifications

General

Type	Tool setting probe
Hard-wired	Yes
Repeatability	1.0 µm (0.00004 in) 2σ
Stylus Tip Diameter	2 mm
Operating Voltage	5 V DC
Operating Temperature Range	5°C to 50°C
Storage Temperature Range	–10°C to 70°C