To Next PageTo Next PageWhy does my Renkforce 3D Printers printed object not adhere to the build bed?
If the printed object does not stick to the build bed, it could be due to several reasons. The nozzle temperature might be too low, so try increasing it. There might be residues on the build bed, so clean it. The print speed could be too high, so reduce it. Consider recalibrating the build bed. You can also try adding a raft to the print object.
How to fix Renkforce 3D Printers no USB connection?
If you cannot establish a USB connection to the 3D printer, check the USB line connection. Ensure the correct USB port is selected in the software and that the necessary drivers are installed. Try unplugging and then re-plugging the USB cable, switching the 3D printer off and on again, or restarting your computer. You can also try using a different USB port on your computer or connecting the 3D printer directly to a USB port without using a USB hub.
What to do if Renkforce RF100 filament becomes stuck during unloading?
If the filament becomes stuck during unloading, try loading and unloading the filament again.
What to do if Renkforce RF100 nozzle cools down unexpectedly?
If the nozzle cools down unexpectedly, select < Preheat PLA> to reheat the nozzle and have further action within following 5 minutes for example load/ unload filament, printing etc.
How to remove Renkforce 3D Printers printed object from build bed?
If the printed object cannot be removed from the build bed, wait until it has cooled down. If it still sticks, use the scraper to remove the object.
General| Filament Diameter | 1.75 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD card |
| Print Technology | Fused Deposition Modeling (FDM) |
| Print Speed | Up to 100 mm/s |
| Supported Materials | PLA, ABS |
