Renkforce RUSD-1803BT - B) Menu Settings

41
Setting the Time
• Keep the button PTY/CLK (18) pushed until the time is displayed.
• PushandholdthePTY/CLK(18)buttonagainuntilthehoursdisplayashes.
• Set the hours by turning the rotary control (3).
• Push the rotary control (3) and adjust the minutes by turning the rotary control (3).
• PushandholdthePTY/CLK(18)buttonuntilthedisplaystopsashingtosavethesetting.
OPEN button (7)
• Press this button to unlatch the control panel.
RESET function
• This function resets all settings to factory settings.
• Push the button RESET (22) with a pointy object (e.g. a straightened paper clip) in the following cases:
- when you have completed the installation and connection
- when the device does not react to the operation of buttons any more
- whenthedisplayshowsundenedcharacters
b) Menu Settings
Toselectthemenusettings,pushtherotarycontrol(3)brieyorforalongertimetocallthetwolevelsofthemenus.
Therstlevelservestosetmorefrequentlyusedfunctions,whilethesecondlevelonlycontainsfunctionsthatare
needed less often.
Choose the options for the respective settings by turning the rotary control.
Depending on the source (radio unit, USB playback etc.) that is currently active, only some functions may
be available.
Menu items - Push the rotary control (3) briey
BAS > TRE > BAL > FAD > LOUD > EQ > STEREO/MONO > LOC > BEEP
• BAS controls the low frequency range
• TRE controls the high frequency range
• BAL controls the volume ratio between the right and left speakers
• FAD controls the volume ratio between the front and rear speakers
• LOUD ON/OFF
LOUD ON >> The loudness function is active.
LOUDOFF>>Theloudnessfunctionisinactive.Thesoundisnotinuenced.
At low volumes the human ear does not perceive very low and very high sounds well. An increase of the
frequency range for low volume (loudness correction) counteracts this effect and the music replay sounds
more natural.