What to do if the protective circuitry is activated on a Renkus-Heinz Amplifier?
If the protective circuitry for a channel in your Renkus-Heinz Amplifier has been activated, it indicates a potential issue. First, check the channel for a shorted line. Then, turn the amplifier off and on again to see if the circuitry resets. If it does reset, overheating was likely the cause, and the temperature has now returned to a safe level.
What to do if my Renkus-Heinz Amplifier is being overdriven?
If your Renkus-Heinz Amplifier indicates it's being overdriven, reduce the system level and avoid extreme equalization. Consider adding more amplifiers and/or loudspeakers to the system to handle the load.
What to do if my Renkus-Heinz P3501 Amplifier's loudspeaker is receiving too much power?
If the loudspeaker connected to a channel of your Renkus-Heinz Amplifier is receiving too much power, and the controller's protective circuitry has activated, reduce the signal level.
Why won't the power switch stay on for my Renkus-Heinz P3501?
If the power switch on your Renkus-Heinz Amplifier won't stay on, it indicates a failure. Immediately disconnect the amplifier from operation and have it serviced by a qualified technician. Do not attempt to hold the switch on, as this may cause significant damage.
What to do if my Renkus-Heinz P3501 is not receiving a signal?
If your Renkus-Heinz Amplifier isn't receiving a signal, ensure the source is sending a signal and that the interconnecting wiring is not faulty. Check all connections to ensure they are secure and functioning correctly.
How to troubleshoot a Renkus-Heinz P3501 that won't turn on?
If your Renkus-Heinz Amplifier appears to be off or not receiving power, check that the power cord is properly connected to a suitable outlet and verify that the outlet provides the correct voltage. Also, ensure that the amplifier is switched to the "on" position.
Consolidates warnings about electric shock, rain, and moisture exposure.
Advises against opening the unit and directs servicing to qualified personnel.
Details output ratings, frequency response, distortion, noise, sensitivity, impedance, gain, slew rate, damping factor, and voltage swing.
Covers power requirements, protection, filters, LEDs, cooling fans, and circuit breaker.
Details chassis, face panel, finish, front/rear controls, and connectors.
Explains protection LEDs for controller modules on P3500 and their function.
Details the specific loudspeaker controller module's protective and signal processing functions.
Addresses issues like no power, no signal, or no sound output from the amplifier.
Explains red LEDs, single channel issues, and protection circuit activation.
General| Power Output | 350 W @ 8 Ohms, 500 W @ 4 Ohms |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 100 dB |
| Damping Factor | > 200 |
| Cooling | Convection |
To Next Page
