FlexiPanels
®
Basic HMI
© Renu Electronics Pvt. Ltd.
Page 5 of 20
Safety Precautions
This section of the manual provides information that is critical regarding safety and therefore the
user is advised to go through the information in detail before installing the product. Users may
contact RENU Electronics technical support team at support@renuelectronics.com for any
specific question(s) related to safety.
WARNING: EXPLOSION HAZARD
Do not disconnect equipment unless power has been removed or the area is known
to be nonhazardous.
The substitution of any component may impair suitability for Class I, Division 2.
Secure any external connections that mate to this equipment by using screws, sliding
latches, threaded connectors, or any other means provided with this product.
If this product contains batteries, it must only be changed in an area known to be
nonhazardous.
CAUTION: GENERAL PRECAUTIONS
Do not use this product for an emergency stop. A separate physical switch, outside
the product, must be used for any emergency stop operations.
Do not use the external power supply source that does not comply with the specified
power requirements of the product, it may cause malfunction or permanent damage
to the product.
Do not attempt to open, dismantle, or modify the product, doing so will void the
warranty.
This product is supplied as open-type equipment and it must be mounted within an
enclosure, suitably designed for specific environmental conditions.
When used in Class I, Division 2 hazardous location, the product must be mounted
in a suitable enclosure with a proper wiring method that complies with the governing
electrical codes.
The USB port is intended for temporary local programming purposes only and not
intended for permanent connection. If you connect or disconnect the USB cable with
power applied to this product or any other device on the USB network, an electrical
arc can occur, which could cause an explosion in hazardous location installations.
Make sure that connectors are securely tightened to properly seal the connections
against leaks.
Do not place the product in direct sunlight. Prolonged exposure to sunlight may
degrade the LCD and housing.
To Next Page
Loading...