Renu Electronics FlexiPanels Basic HMI FP2070TN-V2 - Mounting, Power, and Grounding; Mounting FP2-V2 Products; Connecting Power

FlexiPanels
®
Basic HMI
© Renu Electronics Pvt. Ltd.
Page 8 of 20
Mounting FP2-V2 Products
FP2-V2 series products must be installed on the front panel, using the clamp accessories shipped with
the product. Before mounting, make sure that the sealing gasket is properly positioned. This gasket forms
a compression type seal. Do not use sealing compounds. Then, place the unit in the panel cutout and
tighten the mounting screws evenly (torque 0.4Nm) to maintain water and dust resistance.
ATTENTION
ATTENTION: Mounting FP2-V2 on Panel
 Do not push the LCD display when pushing the unit into the panel as it may damage
the display.
Connecting Power
FP2-V2 series requires a 24VDC isolated power supply. Follow the steps mentioned below to connect
the power:
 Make sure that terminal is not connected to a power source
 Secure the 24VDC power wires
 Secure the functional earth ground wire to the functional earth ground terminal screw on the
terminal block
 Apply 24VDC power to the terminal
Power Rating
Unit
Voltage
Current
Wattage
FP2043T-V2
24VDC
130mA
3.12W
FP2043TN-V2
24VDC
150mA
3.6W
FP2070T-V2
24VDC
200mA
4.8W
FP2070TN-V2
24VDC
230mA
5.52W
Grounding
The optimum method for grounding electronic equipment is to ground it separately from other high-power
systems and to ground more than one unit of electronic equipment with a single-point ground. Following
marked terminal is provided with the unit for grounding: