Reolink E1 Outdoor

3
English
English
4
Reolink E1 Outdoor
Your Smart Device
Router
Network Cable
Power Cable
Status/LED
Blinking
Solid
LED in Blue
WiFi connection failed
Camera is starting up
WiFi is not configured
WiFi connection succeeded
Power Adapter
Set up the Camera
Wired Setup
It is recommended that the initial setup be completed with the Ethernet cable. You may follow the
steps below to set up your camera.
Step 1 Connect the camera to a LAN port on your router with an Ethernet cable.
Step 2 Use the power adapter provided to power on the camera.
Camera Introduction
Reset Button
* Press for more than five seconds to
restore the device to default settings.
Micro SD Card Slot
reset button and the SD card slot.
Daylight Sensor
Spotlight
Infrared Lights
Lens
Status LED
Built-in Mic
Speaker
Network Cable
Power Cable
Meaning of the Status LED:
* Rotate the lens to find the