Reolink Go PT

English English3 4
OFF
OPEN
ON
POWER
RST
MicroSD
RST
MicroSD
Nano SIM
Set up the CameraCamera Introduction
Activate SIM Card for the Camera
Insert the SIM Card
• The SIM card shall support WCDMA and FDD LTE.
•SomeSIMcardshaveaPINcode.YoumayuseyoursmartphonetodisablethePINfirst.
Rotate the camera lens, and remove the rubber cover.
Speaker
Status LED
Lens
Built-in PIR Sensor
Daylight Sensor
Built-in Mic
Reset Hole
Nano SIM Card Slot
Micro SD Card Slot
Micro USB Port
Antenna
Battery Status LED
Power Switch
* Press the reset button with a pin to restore
camera to factory settings.
* Please always cover the USB charging port with
rubber plug after charging the battery.
*Rotatethecamera’slenstofindtheresethole,
SIM card slot and SD card slot.
NOTE: Do not insert the IoT or M2M SIM into your smartphone.