RC3000 Antenna Controller Chapter 2 Installation
32
2.2.8 RF Autopeak
J11 (Type F Female connector on backpanel) is the input to the RF Autopeak circuit. This input accepts
the output of an LNB (950-2150MHZ, -50 to –5dBm.)
The RF autopeak module inside the RC3000 produces an output proportional to the broadband energy
received. The RF autopeak circuitry includes a “DC block”. When this input is being used, it is indicated
on RC3000 screens as the “RF” signal source.
See sections 2.4.3.1 and 3.3.1.2.6 regarding use of the L-Band power detector input.
To Next Page
Loading...