iGo map Operation
Tap to enable or avoid freeways, tap for
roads with Period Charge or Per-use Toll, tap for
ferries, or tap for carpool lanes.
(optional) If necessary, tap then and
enter the coordinate in UTM format.
4. A full screen map appears with the selected point in
the middle. If necessary, tap the map somewhere else
to modify the destination.
The cursor ( ) appears at the new location.
5. Check the settings for road types and change them
if necessary.
Note:
6. Tap to confirm the destination.
You can also select a nearby point on the map
or tap to select a different destination.
7. The route is calculated and the map appears
showing the entire route, where you can check route
information and route alternatives. Tap to
modify the route parameters, or tap to
start your journey.
3.1.8 Selecting a location on the map
To select a map location, perform the following steps:
1. Locate your destination on the map. Move and
scale the map as necessary.
2. Tap the location that you want to select as your
destination. The cursor ( ) appears there.
3. (optional) If needed, tap to list
the Places near the selected point or to save this
location.
52
To Next Page
Loading...