ResMed S8 AutoSet II User Manual

5Changing the Settings on your S8 II Device
English
Stopping Treatment
To stop treatment at any time, remove your mask and press .
If your clinician has enabled SmartStart, simply remove your mask and treatment will
end.
Changing the Settings on your S8 II Device
You can change settings (such as Ramp Time, EPR Level) on the S8 II by using the
keypad and LCD. When the device is in standby mode you can display a series of
screens (a menu) on the LCD screen in order to view and change the settings for a
particular function.
The Standard Menu
Your clinician will have enabled the menu on your S8 Series II device. The picture
shows the standard menu in each mode.
Note: The AutoSet menu is available on the S8 AutoSet II only.
To enter the standard menu from the standby (RAMP or SETTLING) screen, press
.
S8 CLASSICRAMP: 10min
menu
S8 CLASSIC
WELCOME
>>>>>>
S8 CLASSICSETTLING: 10min
menu
S8 CLASSIC
WELCOME
>>>>>>
EPR LEVEL: 1
change exit
CPAP
AUTOSET
MASK: ULTRA
change exit
exit
SW: SX4800100
USED HRS: 08000
exit
USAGE: 1000/1068
exit
MASK: ULTRA
change exit
exit
SW: SX4800100
USED HRS: 08000
exit
USAGE: 1000/1068
exit
EPR LEVEL: 1
change exit
* Only displayed if access set by clinician.
*
*

ResMed S8 AutoSet II Specifications

General

Brand	ResMed
Model	S8 AutoSet II
Category	Health Care Products
Language	English