Respironics OptiLife User Manual

OptiLife
™
Patient & Clinician Fitting Guide
FITTING THE CUSHION
Finding the right size pillows cushion
If using the plastic sizing gauge, insert each size into the nostril. The bottom
rim of the gauge should not go into the nostril. Choose the size that best
seals the nostril. When choosing between sizes, choose a larger size for a
more robust seal with less insertion into the nostrils.
Select a cushion that fills the nostrils comfortably without any gaps between
the cushion and the walls of the nostrils. The bottom rim of the cushion
should not go into the nostril.
1. Look at the markings on the pillows cushion to determine the correct
placement of the cushion onto the cushion attachment hub. The arrow
on the cushion and the arrow on the interface should be on the same side,
but may not align perfectly.
2. Attach the pillows cushion to the cushion attachment hub. This should be
done one side at a time. Place the hole located on the side of the cushion
over the corresponding post located on the hub.
3. Stretch the cushion over the cushion hub
to attach the other side of the cushion.
The cushion will stretch without tearing.
4. For proper placement of the cushion into
the nostrils, rotate the cushion on the hub
at approximately a 45° angle before
inserting it into the nose.
ATTACHING THE CUSHION
45°

Respironics OptiLife Specifications

General

Type	Nasal Pillow CPAP Mask
Manufacturer	Respironics
Cushion Material	Silicone
Pressure Range	4-20 cm H2O
Size Options	Small, Medium, Large
Compatibility	Compatible with most CPAP and BiPAP machines
Weight	0.16 lbs (approximate, mask with headgear)
Dimensions	Varies by size
Humidifier Compatibility	Yes
Power Requirements	N/A (machine dependent)
Therapy Modes	CPAP, BiPAP

Summary

Fitting the Cushion

Cushion Sizing and Seal

Selecting the right cushion size using a gauge for optimal seal and comfort in nostrils.

Attaching the Cushion

Cushion Placement and Hub Attachment

Aligning cushion markings and attaching it to the hub, then stretching to secure.

Nostril Insertion Technique

Rotating the cushion on the hub to a 45° angle for proper nostril insertion.

Putting On and Adjusting the Interface

Initial Cushion Placement and Headgear Application

Placing the cushion in nostrils and pulling the back strap over the head.

Headgear Strap Positioning

Correct placement of back, top, and side straps on the head and above the ears.

Side Strap Adjustment

Adjusting side straps evenly to ensure comfortable cushion fit in nostrils.

Chin Support Band Adjustment

Adjusting the chin strap for a snug fit, allowing slight mouth opening.

Fine-Tuning Cushion Fit

Rotating the cushion on the hub for optimal comfort after initial fitting.

Removing the Interface

Headgear Fitting Tips

Side Straps Over Ears Correction

Adjusting the top strap to move side straps off the ears for correct positioning.

Sliding Back Strap Correction

Adjusting top and back straps to prevent the back strap from sliding down.

Hair Management with Headgear

Placing long or silky hair over the back of the headgear strap for comfort.

Cushion Seal Fitting Tips

Troubleshooting Cushion Seal Issues

Tips including trying different cushion sizes, checking chin band tightness, and adjusting strap placement.

Adjusting Fit While Lying Down

Re-adjusting mask fitting while in a lying down position for optimal comfort.

Tube Management

Optimizing Mask Stability with Tubing

Using the provided Velcro ring to manage CPAP tubing for improved mask stability.