Restube Active - Troubleshooting; Storage, Care, Maintenance, and Disposal

20
WARNING
If the buoy is not positioned correctly in the pocket, correct release is not
guaranteed!
• Position the folded buoy in the pocket so that the trigger mechanism is
facing the label with this symbol
>>> The trigger cord must hang out of the pocket
• Store the rest of the safety leash in the pocket next to the cartridge
>>> Do not store safety leash in the key compartment in the ap
• Close the ap of the pocket
• Close velcro 6a & 6b
3. Troubleshooting
Problem Cause Corrective action
Buoy does not t into
the pocket
Buoy is not fully emptied > Empty buoy completely
Velcro does not
close
Buoy is not folded correctly
Buoy is not positioned
correctly in the pocket
> Observe packaging instructions
> Trigger mechanism must face the
label with this symbol
CO2 cartridge is
pierced immediately
when screwing in
The release lever was not
switched before screwing
in the new CO2 cartridge
> switch the release lever to the
green postition to avoid piercing
the new CO2-cartridge.
CO2 cartridge can-
not be screwed in or
only screwed in with
much diculty
Dirt on the thread or
trigger mechanism
> Clean the trigger mechanism
Lifespan & storability
RESTUBE products are designed to have a long lifespan and can be triggered from 50 to 250(*)
times, depending on the version. Once used, the device is to be stored outside its packaging, well
ventilated and at a maximum temperature of 28°C. The maximum lifespan of the device is 5 years
from the date of purchase, assuming that the care and maintenance instructions are followed.
If used frequently (more than once per week) or in tropical climates, the product lifespan may be
shorter. If humidity is high, the device should be removed from its box. Do not put RESTUBE products
on radiators and do not dry or store them in direct sunlight.
Care
Maintain your RESTUBE product after every use. Five minutes of your time will help to make sure
that you carry on being able to enjoy the product.
>>> Take the bladder out of its bag and check all parts for external damage: Bag, bladder, trigger,
trigger cord and CO2 cartridge. None of the components should show signs of heavy use, signicant
rust or damage.
>>> Following use in saltwater or chlorinated water: Remove the bladder from its bag, and rinse
both in fresh water, ensuring that the oral valve is closed and that the cartridge is screwed in rst. If
the product has become particularly dirty, wash it with mild detergent or a weak solution of lye and
rinse it with fresh water afterwards. Do not use cleaning agents which contain alcohol or solvents.
4. Storage, care, maintenance and disposal of your RESTUBE product
(*) Restube active: Up to 100 times