Retekess TD173 - Prompt Settings (F2); Prompt Time Setting (F3); Transmitter ID Setting (F4)

03
Note: If there is no operation within 10s since the pager is removed from the charging slot, The system will
automatically exit the pairing mode
5.2. Prompt Settings (F2)
On the charging mode
A. Press [Set] key to enter setting mode, the F1 is shown on display
B. Press “△” key, F2 is shown on the display
C. Press [Call] key to enter the sub-menu
D. Press “△” or “▽” key to select the desired value
E. Press [Call] key to confirm, the transmitter emits a beep to indicate that the setting is complete, F2 is shown on
the display at this time
F. Press [Back] key to exit the setting mode
Code Description
000: Keyboard prompt mode: Mute
001: Keyboard prompt mode: Beep
002: Keyboard prompt mode: Vibration
003: Keyboard prompt mode: Beep and Vibration
004: Pager prompt mode: Beep
005: Pager prompt mode: Vibration
006: Pager prompt mode: LED Flash
007: Pager prompt mode: Beep and Vibration
008: Pager prompt mode: Vibration and LED Flash
009: Pager prompt mode: Beep and LED Flash
010: Pager prompt mode: Beep and Vibration and LED Flash
5.3. Prompt Time Setting (F3)
On the charging mode
A. Press [Set] key to enter setting mode, the F1 is shown on display
B. Press “△” key twice, F3 is shown on the display
C. Press [Call] key to enter the sub-menu
D. Enter the desired prompt time (1-999S) through the keyboard
E. Press [Call] key to confirm, the transmitter emits a beep to indicate that the setting is complete, F3 is shown on
the display at this time
F. Press [Back] key to exit the setting mode
5.4. Transmitter ID Setting (F4)
A. Press [Set] key to enter setting mode, the F1 is shown on display
B. Press “△” key 3 times, F4 is shown on the display
C. Press [Call] key to enter the sub-menu
D. Enter the desired transmitter ID (1-999) through the keyboard
E. Press [Call] key to confirm, the transmitter emits a beep to indicate that the setting is complete. F4 is shown on
the display at this time
F. Press [Back] key to exit the setting mode
Note: You have to re-pair all the pagers after changing the transmitter ID