What to do if Retekess TD183 pager can't be called?
If your Retekess Microphone pager isn't responding to calls, there are a couple of things to check: * Ensure the pager has sufficient power by recharging it. * Make sure the pager is within the specified transmission distance.
Why Retekess TD183 Microphone pager can’t be programmed?
If you're having trouble programming your Retekess Microphone pager, it might be due to these reasons: * The pager may not be charging. Ensure the pagers are in charging mode. * It may exceed 20s since connecting the power. Try again within 20s after recharging.
Instructions for powering on the system and charging pagers.
How to make a call to a specific pager.
Solutions for when the pager fails to program.
Solutions for when the pager cannot be turned off.
Solutions for when the pager does not respond to calls.
Important safety precautions for operating the device.
電源を切る手順。
トラブルシューティング。
General| Microphone | Condenser |
|---|---|
| Charging Voltage | 5V |
| Connector | 3.5mm |
| Color | Black |
| Type | Wireless |
| Transmitter Power | 10dBm |
| Frequency Response | 50Hz |
To Next Page
