Installing Batteries
To install or replace batteries:
1.Remove belt clip by releasing belt clip latch and sliding clip up.
2.Pull up on the battery door latch to remove the battery compartment
cover.
3.Insert the supplied three AA rechargeable batteries or non-recharge-
able alkaline batteries. Position batteries according to polarity markings.
4.Replace battery compartment cover and belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd,
Ni-MH, etc.) batteries.
For charging radio(s):
1.To charge a single radio, simple insert the connector directly into the
charge jack located on the top of the radio.
2.The radio will display a flashing battery icon while charging.
3.Recommends your radio be turned off while being charged.
4.Non-rechargeable alkaline batteries can also be used on your radio.
Quick Start
1.Press and hold the Menu/Power button to
turn on your radio.
2.Press the Menu, press the Up or Down
button to select a channel.
3.Press and hold the Talk button while
speaking into the microphone.
4.When finished talking, release the Talk
button and listen for a response.
Both radios must be tuned to the same
channel/privacy code to communicate.
3
To Next Page
Loading...
