11.1 Setting the Call Tone
The walkie talkies have 10 call tones.
• Press the MENU-button (11) four times, “CA”is displayed and the current
call toneis flashing.
• Press the ▲-button (4) or the▼-button (7) to change to another Call Tone.
• Press the TALK-button (15) to confirm and return to stand-by.
11.2 Sending a call tone
Press the CALL-button (12) briefly. The call tone will be transmitted on the
set channel.
12.Setting the double channel monitor
• Press the MENU-button (11) five times ,until the “CH” displays the current
channel flashes.
• Press up or down key to set the scond channe or turn off.
• Press the TALK -button (15) to confirm and return to stand-by.
13.Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press the MENU-button (11) six times.
• Press ▲ to enable (ON) or ▼ disable the Key Tones (OF).
• Press the TALK -button (15) to confirm and return to stand-by.
14.Roger Beep On/Off
After the TALK-button is released, the unit send out a roger beep to confirm
that you have stopped talking.
To set the Roger Beep.
• Press the MENU-button (11) seven times, “ro” will displays.
• Press ▲ to enable (ON) ▼ disable the Key Tone (OF)
• Press the TALK -button (15) to confirm and return to stand-by.
15.Setting the TX power high/low
• Press the MENU-button (11) eight times, “Pr” will be displayed
• Press up or down key to set the HIor LO lever.
• Press the TALK -button (15) to confirm and return to stand-by.
16.Button Lock
• Press and hold the MENU-button (11) for two seconds to activate the
Button lock mode. The button lock icon is displayed on the LCD Screen.
• Press and hold Menu button until there are the Lock icon displayed on the
LCD Screen.The same step to unlock the button.
Note: The TALK-button (15), the CALL-button (12), MON-button (5) and the
.
7
To Next Page
Loading...
Need help?
General
