Installation
Set up the BB 200 only a flat and solid surface. Anchoring is not
absolutely necessary since the vibrations transmitted to the
environment by the free mass moments will be only barely
perceptible. The machine may, if desired, be anchored using the
holes in the feet as shown in Fig.1.
Electrical connection
* Refer to the data plate for information on the voltage and
frequency at which the BB 200 is to be operated.
* Ensure that the values shown there correspond to those for the
local power supply.
* Use the supplied power cord to connect the BB 200 to the
power supply.
* When connecting the power cord to the power source, be sure
that the supply circuit is fused in accordance with local codes.
Failure to observe the values on the data plate can
cause damage to either the electrical or the mechanical
components or both.
To Next Page
Loading...