Revitive Essential RLV - Page 9

16 17
g
Press the Body Pads on the area you wish to apply electrical stimulation to, as
shown on page 14, gently pressing the adhesive side against the skin.
h Press the power button on the Revitive.
You will hear a beep and the display lights will read 30 minutes.
To turn o the device at any time during operation, press the power button.
i Press the (+) Intensity Control one time to start stimulation.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
j Ensure you familiarise yourself with the feeling of Electrical Muscle Stimulation (EMS). Use on a low intensity
for 30 minutes once per day for a few days.
It is normal to feel tingling or varying sensations in your muscles you are treating.
k Aer a few days of familiarisation, use a higher intensity that provides you with strong but comfortable muscle
contractions.
You can set the intensity between 1-50.
Please note that the intensity required may vary from day to day.
l The time display will start to count down in minutes as Revitive cycles through its program.
m When Revitive times out, the time display reads 00 and you will hear three beeps, and the device will
switch itself o automatically.
Instructions for use
EN
R
R
R
R
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the (–) Intensity Control.
• You can also choose to stop therapy before the end of the 30 minute session to avoid skin irritation. You can do this
by pressing the power button.
n Ensuring that the device has switched itself o, then gently peel the Body
Pads from the skin.
Do not pull the Body Pads o the skin using the Electrode cords as this
may damage the cords.
o Replace the Body Pads onto its plastic liner aer use.
p Unplug the Electrode cord from the opening on the device.
You do not need to detach the Body Pads from the Electrode cord.
8034_IFU01_18976655.indd 17
8034_IFU01_18976655.indd 17
08/02/2023 09:22
08/02/2023 09:22