Revitive Essential RLV - Step 3: Using the Body Pads

14 15
Step 3: Using the Electrode Body Pads
Electrode Body Pads are for single person use only. Do not share body pads with others.
Revitive comes with one pair of reusable (up to 20-30 applications) Electrode Body Pads that can be used to deliver
targeted electrical stimulation.
The Body Pads cannot be used at the same time as the foot-pads.
Using the Body Pads will automatically turn the foot-pads o.
a Select the area you wish to apply electrical stimulation to.
Example Body Pad placements are shown below:
✔
Use Revitive Body Pads in EMS mode as and when required, from 30 minutes per day.
Do not use Revitive in EMS mode for more than 6 sessions of 30 minutes (or the equivalent) per day. This may
result in muscle fatigue.
Instructions for use
EN
Inside of Ankle/foot
✔
✔
Caf
Thigh
✔
Outside of Ankle/foot
✔
✔
Do NOT use the Body Pads on your head, face, neck or chest
b Clean and dry the area where you will place the Body Pads.
c Make sure Revitive is switched o. If the control panel is still illuminated, press the power button and turn Revitive o.
d
Attach the ends of the electrode pad to the electrode cord.
Press connectors until there is no gap between them.
Leaving a gap may cause discomfort or no stimulation.
e Plug the other end of the Electrode Cord into the opening on the side of Revitive.
Plugging in the Electrode Cord will automatically turn the foot-pads o.
f Remove the plastic liner from the Body Pads, by peeling it o carefully. Replace
the Body Pads onto the plastic liner aer use.
8034_IFU01_18976655.indd 15
8034_IFU01_18976655.indd 15
08/02/2023 09:22
08/02/2023 09:22