1307SDH_RDH--EN,page 3/32
MOVING and UNCRATING
This unit was test operated and inspected at the factory
prior to packaging and was in proper operating condition.
Before leaving the factory, the unit is completely
assembled. If the heater has incurred damage in
shipment, document the damage with the transport
company and contact your supplier.
Read this booklet and become familiar with the
installation requirements of your unit. If you do not have
knowledge of local requirements, check with the gas
supplier and any other local agencies that might have
requirements concerning this installation.
Before beginning, make preparations for necessary
supplies, tools and manpower.
IMPORTANT : SDH model
If the installation includes optional vertical louvers
or downturn nozzle etc., install these options
before the heater is suspended. Follow the
instructions included in the option package.
When transporting the appliance after it has been
unpacked (i.e. fork lifting, etc) note the restrictions and
recommendation indicated in figure 1.
The base frame contains internal support member, which
acts as a lifting fulcrum point to prevent damage to the
underside of the appliance by lifting forks.
Figure 1: Appliance Handling Criteria
Min. fork length requirement
Min. fork width for balance
TECHNICAL DATA
Table 1a :Gas category SDH/RDH
Country Gas category Country Gas category
Belarus II2H3+ Montenegro II2H3+
Bulgaria I2H or I3B/P New Zealand II2H3+
China II2H3+ Norway II2H3 B/P
Czech Republic II2H3+ Poland II2E3P
Croatia II2H3P Portugal II2H3+
Cyprus II2H3+ Romania II2H3P/II2L3P/I2E
Denmark II2H3 B/P Russian Federation I2H or I3P
Estonia II2H3+ Serbia II2H3+
Finland II2H3 B/P Slovakia II2H3+
Greece II2H3+ Slovenia II2H3+
Hungary II2HS3P Spain II2H3+
Iceland II2H3+ Sweden II2H3 B/P
Latvia II2H3+ Turkey II2H3+
Lithuania II2H3+ Ukraine I2H or I3P
2
3
To Next Page
Loading...
Need help?
General
