EasyManuals Logo

Reznor UDX Kit Installation

Reznor UDX
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Revision: UBX-UBZ-UDX-UDZ-HX (02-22) 1037154-0
HEAT EXCHANGER GASKET KIT INSTALLATION
FOR UNIT HEATERS
Supersedes: — (Original Version)
MODELS UBX, UBZ, UDX, AND UDZ
Table 1. Heat Exchanger Gasket Kit Components
Item
No.*
Component Size
Unit Size
030, 045 060, 075 100, 125 150, 175, 200 225, 250 300, 350, 400
Kit PN
1036360 1036361 1036362 201670 201671 201672
Component PN (Quantity)
1
Top/bottom header
panel gasket
5/8 × 21-3/8 1033925 (2) 1033925 (2) 1033925 (2)
1 × 35-23/64 194533 (2) 194533 (2) 194533 (2)
2
Front/rear heater
panel gasket
5/8 × 12-5/8 1033922 (2)
5/8 × 15-5/8 1033923 (2)
5/8 × 23-5/8 1033924 (2)
1 × 20-3/16
195986 (2)
1 × 26-3/16 195987 (2)
1 × 34-3/16 195988 (2)
3
Tube support
gasket
1 × 89-7/32 201424 (1)
1 × 95-7/32 201425 (1)
1 × 103-7/32 201426 (1)
*See Figure 1.
INSTALLATION
⚠ DANGER ⚠
Improper installation could result in death, serious injury, and /or property damage. The qualified
agency performing this work assumes responsibility for this installation.
Proper installation and sealing of the heat exchanger to the heater is necessary for reliable and
safe operation. Failure to properly install could result in property damage, personal injury, and/
or death.
The replacement heat exchanger should be installed by a qualified service agency in compliance
with all codes and requirements of authorities having jurisdiction.
NOTE: Unit sizes 030–125 require the installation of four (4) gasket strips. Unit sizes 150–400 re-
quire the installation of five (5) gasket strips.
Install the heat exchanger gasket kit as follows (item numbers refer to Figure 1):
To prevent damage during shipping or storage, gasket kits for replacement heat exchangers are shipped in a
parts bag.
Gasket kits should be attached to the replacement heat exchanger at the time of installation.
All gaskets are self-adhesive and are cut to size.
Refer to the installation manual provided with the heater for important safety information.
Ensure that all components listed in Table 1 are available before beginning installation.

Other manuals for Reznor UDX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Reznor UDX and is the answer not in the manual?

Reznor UDX Specifications

General IconGeneral
ModelUDX
CategoryHeater
Fuel TypeNatural Gas or Propane
Ignition SystemDirect Spark Ignition
InstallationHorizontal or Vertical
Heat Exchanger MaterialAluminized Steel
DimensionsVaries by model
WeightVaries by model
Heating Capacity30, 000 to 400, 000 BTU/hr
Efficiency83%
Vent TypeSeparated Combustion
Voltage115V
Control TypeThermostat
TypeGas-fired unit heater

Related product manuals