RF Technologies Code Alert CA630 - Chapter 4; Caring for Your System; Troubleshooting Your System

CHAPTER 4 Maintenance
CA630 In-Service Manual Guide Page 17 of 23
0510-1116-C
CHAPTER 4
Maintenance
Caring For Your System
 Do not immerse the control unit in liquid; dry clean with alcohol wipe.
 Do not carry or move the control unit or the sensor pad by the cable(s).
NOTE: Remove the 9-volt alkaline battery from the control unit if the CA630 Fall
Management System will not be used for a prolonged period.
Troubleshooting Your System
1. If the control unit issues a Fall Alert but the resident has not left the bed or
chair, check the position of the Sensor Pad.
2. If the control unit does not issue an alert when the resident leaves the bed or
chair:
 Check to see that the battery is properly connected and operational; the
green light on the control unit should blink every 2 seconds.
 Check to see that nothing is obstructing the buzzer holes.
 Check the position of the Sensor Pad. Refer to the instructions on the
Sensor Pad for placement of the pad on the bed or chair.
 Check to see that the Sensor Pad plug is properly inserted in the proper
jack on the control unit.