RFRemotech MS Series - User Manual

MS Wireless Firing System
For Pyrotechnics and Fireworks Show
RFRemotech Radio Frequency Remote Technology
Remote Control Products, Remote Controllable Service
Warnings:
The purpose of this device is to cause the ignition of fireworks. Fireworks are explosives and may cause
personal injuries or death to yourself or others, including spectators. You are responsible for the safe and
legal use of this device according to the laws and regulations of your country and/or state/province/district.
RFRemotech is not responsible for illegal or unsafe use of this device. The buyer/user assumes all
responsibility and liability in the use of this device and further agrees, by purchase and/or use of this device,
to indemnify and hold harmless RFRemotech against all liability for injury, loss, or damage direct or
consequential arising out of the use of, or inability to use this device.
You must perform the safety tests (Page 4)
every time you use the receiver.

Summary

Warnings and Safety Precautions

Product Overview and Components

Transmitter Description

Details on Transmitter A and Transmitter B models, including their features and button layouts.

Receiver Specifications

Specifications and features of the RF12 receiver, including cues, power, and range.

System Components Identification

Illustrates and lists the physical parts included in the MS Wireless Firing System.

System Operation Modes

Instant Firing Mode

Using Transmitter A for immediate firing of selected cues.

Firing-In-Sequence Mode

Using Transmitter B for sequential firing of cues with adjustable intervals.

Pre-Use Setup and Safety Checks

Battery Installation

Instructions for connecting internal AA or external SLA batteries to the receiver.

Essential Safety Tests

Procedure for performing critical safety tests before attaching igniters.

Advanced Functions and Features

Learn and Clear Codes

Synchronizing transmitters to receivers and clearing learned codes.

Continuity Testing

Verifying e-match/igniter connections using the test function.

Arming the System

Preparing the receiver for firing after successful testing.

Wired Control Mode

Operating the receiver via a MASTER unit through RS485 ports.

Low Power Alarm

Understanding the low battery warning indicator and required actions.

Digital Readout Meter

Interpreting the display of battery voltage, receiver ID, or logic ID.

Viewing Receiver ID

RFRemotech MS Series Specifications

General

Model	MS Series
Category	Remote Control
Control Distance	100m (open area)
Relay Contact Rating	10A 250VAC / 10A 30VDC
Type	RF
Operating Voltage	12V DC
Channels	1-4 channels
Operating Temperature	-20°C to +70°C
Operating Frequency	433.92MHz
Frequency	433.92MHz